After selecting the block make sure directory is pointing to iec library folder (was nfpa). If you insert same symbol on the same drawing, you may need to swap the blocks (preciously you had issue with) using command AESWAPBLOCK, select option B.To remove symbol libraries after the installation: Remove the folder of the unneeded library standard manually from Windows Explorer. Replace NPFA with IEC as shown below (marked in RED), then save and close. Solution: For AutoCAD Electrical 2022 and higher By default all the provided manufacturer content as well as symbol libraries are fully installed.Open WD.ENV (in notepad) which is in the AeData folder (along with the Proj and Tutorial folders). Are they IEC or NFPA (I guess they are NFPA)? Click + of the Schematic Libraries to find out the default symbol libraries.In the Project Settings tab click Schematic Libraries then click Default. Check your project properties: right click project> properties.Check your project Settings: right click project>Settings, in the lower window you can see what symbol libraries are used – IEC or NFPA?.What is happening here is your project is IEC standard project ie it supposed to symbols from IEC library folder whereas ACADE is defaulted to NFPA standard ie WD.ENV file is telling ACADE to use NFPA Symbols instead.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |